Linear Gate Repair Nationwide

Linear Gate Repair in Brooklyn: What to Know First

We repair Linear gate systems across Brooklyn, from Park Slope to Marine Park, and most jobs are done in a single visit. A typical Linear control board replacement runs $285 to $420, while a full swing-arm actuator rebuild usually lands between $450 and $750. You’ll see the exact number in writing before we touch anything.

Call (934) 649-3673

This page is for homeowners with a Linear gate that won’t open, opens halfway, beeps without moving, or has started grinding. If that’s you, call (934) 649-3673 and a live person answers, day or night.

Key Takeaways

• We’re an independent Linear service provider, not a manufacturer warranty center
• Most Linear repairs in Brooklyn are diagnosed and completed same-visit
• Written price before any work starts, every time
• We stock Linear-compatible boards, actuators, photo eyes, and remotes on the truck

How Linear Products Fail – and How We Fix Them

Linear has been making gate operators since the 1960s, and the brand shows up all over Brooklyn, especially on older brownstone front gates in Bed-Stuy and Victorian-era driveways in Ditmas Park. Each series has its own personality, and after enough service calls you learn which failure belongs to which generation of hardware.

• Linear LSO/OSCO swing gate actuator: capacitor failure after 6 to 8 years. The motor hums but the gate doesn’t move, or it moves in slow jerks. Brooklyn’s damp winters accelerate capacitor aging. The fix is usually a capacitor replacement, not a new motor, and we do that for under $200. We always check the limit switches while we’re in there because on the LSO series they wear together.
• Linear APeX controller: relay chatter and phantom gate reversals. This happens when the board’s safety circuit picks up moisture or a weak ground. In Brooklyn basements and attached garages that see condensation, it’s one of the most common calls we get. We clean and reseat the terminal block, verify the ground path, and replace the board only if the chatter persists. A new APeX board runs $310 to $395 installed.
• Linear MegaCode receiver: intermittent remote range. If your remote only works from three feet away or stopped working entirely after a storm, the issue is often a cracked antenna or a receiver that took a surge. We test with a signal meter before recommending replacement. MegaCode receivers and remotes are still widely available as new old stock and quality aftermarket equivalents, so you rarely have to replace the whole operator.
• Linear SLR slide gate chain sagging in Brooklyn backyards. Slide gates along narrow driveways in places like Gravesend and Midwood take a beating from sand, salt, and freeze-thaw. The chain stretches, the tensioner bottoms out, and the gate starts slamming or stalling. We re-tension, check the sprockets for wear, and lubricate with a dry graphite where it counts. Most slide gate tune-ups are $185 to $240.
• Linear photoelectric eyes: false “obstruction” trips. These are the wired eyes at the gate columns. When they get nudged out of alignment or the lenses get filmed over with road grime, the gate refuses to close. We realign first, clean the lenses second, and replace third. A misaligned eye is a $95 fix. A dead one is $130 to $180 for the part and labor.

Our Linear Gate Repair Process

Here’s what a Linear repair looks like when we show up in Brooklyn.

1. 1
   We answer the phone. A live person takes your call 24/7, asks what the gate is doing, and asks for the model number if you can find it. That helps us bring the right parts from the truck.
2. 2
   We diagnose before we quote. On-site, we test the control board, check the actuator, inspect the hinges and post, and find what actually failed. You get a written price before any work starts. No pressure.
3. 3
   We explain the parts decision. Where Linear OEM parts make sense, we use them. Where a quality aftermarket equivalent performs identically and costs less, we tell you the difference and let you choose.
4. 4
   We do the repair. Whether it’s a board swap, an actuator rebuild, a hinge replacement, or a full realignment, we work clean. Shoe covers on, drop cloths down, and quiet tools if kids are napping.
5. 5
   We test, then test again. We run the gate through full open and close cycles, check the stop points, the safety reversal, and the entrapment protection. We watch it run a dozen times before we call it done.
6. 6
   We show you the cleanup. Before we leave, we take a photo of the work area and send it to you. Every Linear job is covered by the 365-Day Done Right Promise. If something isn’t right, we make it right.

What Linear Gate Repair Costs in Brooklyn

We’d rather tell you now than let you wonder. Here’s what common Linear work runs in Brooklyn.

• Remote or keypad programming: $75 to $120
• Photo eye realignment or replacement: $95 to $180
• Capacitor replacement on an LSO/OSCO actuator: $160 to $220
• Control board replacement (APeX or MegaCode): $285 to $420
• Swing arm actuator rebuild or replacement: $450 to $750
• Full gate realignment with hinge reset: $250 to $400

What moves the price is part availability, how much steel work the hinges need, and whether the operator is obsolete enough that we need to fabricate an adapter. You’ll see the exact number in writing before we touch anything. Call (934) 649-3673 for a free estimate.

Why Brooklyn Homeowners Call Latch and Post Gate Repair Brooklyn for Linear Work

We’ve been doing gate work in Brooklyn for years now, and Linear keeps finding its way onto our schedule. Some of our regulars live on the brownstone blocks near Prospect Park where iron slide gates and wooden driveway gates each come with their own quirks. Cody Beckman grew up in Los Angeles and learned metalwork at Los Angeles Trade-Technical College before spending the better part of two decades doing gate work full-time. When a Linear operator comes apart in front of us, we know what we’re looking at.

We show up in uniform, with the truck stocked for Linear and the other brands families actually own: LiftMaster, Mighty Mule, Ghost Controls, DoorKing. Every job gets a written price first, shoe covers and drop cloths inside, and a cleanup photo before we leave. The 365-Day Done Right Promise covers everything we install and repair. If it’s not right, we make it right.

FAQs